G2 Message Remote 2
Powers up to two message signs and up to two speaker zones
Key Features
- Most flexible peripheral available
- Contains two independent audio amplifiers
- Can be used to add additional speaker zones to a station


The Phoenix G2 Message Remote 2 (MR2) is a highly flexible peripheral providing support for up to two of our legacy Beta Bright LED signs as well as 2 independent audio zones. The MR2 contains two independent 15 watt audio amplifiers which can power a variety of speakers including our new Sound Sphere speaker. 70 Volt as well as 8 ohm speakers, illuminated and non illuminated are all supported.
Each MR2 channel also has a dry contact input and a dry contact output. These I/O points are programmable to various functions, such as door bells, control valves and switches, lighting controls, etc.
There is a maximum amount of power that can be connected to an MR2 so not all functions are available in all combinations. Consult with USDD to verify that the combination of signs, speakers and I/O does not exceed the maximum power available from the MR2.
The Message Remote 2 is installed quickly and easily, and is a favorite among installers and system designers due to its ability to meet nearly any architectural need.
This is the successor to the original Message Remote.
Dimensions (W x H x D):
6.75 x 9.75 x 2 (in); 172 x 229 x 52 (mm)
Audio outputs:
(2) 20W selectable 8ohm or 70V Speaker Channels
LED lighting outputs:
(2) 48VDC Zoned
Digital inputs:
(2) Dry contact
Digital outputs:
(2) Form C relays rated .5A @48V AC or resistive load only
Network connections:
(1) Ethernet/POE to Station Controller peripheral network
Other connections:
(2) BetaBrite sign power; (2) BetaBrite sign serial control
Voltage outputs:
(1) 48 VDC
Input voltage:
USDD POE
Power consumption:
36W
Related Products
Target specific units or rooms with station alerting messages.
Displays a single-line scrolling alert message.
Provides colorful, immediate dispatch information to the observer.
Want to streamline?
The new stand-alone Phoenix G2 Message Sign requires no additional power from the Sign Remote or Message Remote.
It’s easy to install: just plug in the Power over Ethernet (PoE) cable.